Handspring Treo Battery Installation Guide

	*See a complete list of Handspring PDA batteries* *See other PDA batteries: Compaq iPAQ, Sony Clie, Palm Pilot, Toshiba, Casio and more.* Handspring Treo 180 Battery Installation Guide
The instructions below come with no warranty or guarantee, improper assembly or use of excessive force may result in damage to the parts involved or to your PDA/Mp3 Player. By utilizing these instructions, you agree to hold Laptops For Less blameless and unaccountable for damages or problems caused by use of these instructions. These instruction require a moderate level of technical ability and proficiency in the use of hand tools, as well as a general understanding of electronic components. Buyer assumes full responsibility for the installation of this replacement battery.
		Step 1: Using the included screwdriver, remove the four screws from the case. Using your fingers, pry open the case starting with one of the bottom corners of the PDA. The back of the case should easily unsnap from the rest of the PDA.
		Step 2: Once the case is separated, you will have easy access to the battery and the power cable. The battery is secured by a small amount of glue. Gently pulling on the battery should free it from the PDA.
		Step 3: Disconnect the battery connector by gently pulling on the black and red power cable. Please pay attention to have the original orientation (power cable towards the power connector). Connect the power cable of the new battery by positioning it within the socket on the motherboard, pushing it in. Apply the new battery within the guide brackets...it should stick to the original glue spots. Snap on the cover and put back the four screws. Your new battery will need a minimum of three hours of charging before first use.
©1997- 2005 Laptops for Less Inc. All Rights Reserved. All offers and prices are subject to change without notice.

Back