logo.gif (2999 bytes)

See a complete list of iPAQ PDA batteries

See other PDA batteries: Compaq iPAQ, Sony Clie, Palm Pilot, Toshiba, Casio and more.

IPAQ Battery Installation Guide

 button_order.gif (689 bytes)
The instructions below come with no warranty or guarantee, proper or improper assembly or use of excessive force may result in damage to the parts involved or to your PDA/Mp3 Player. By utilizing these instructions, you agree to hold Laptops For Less blameless and unaccountable for damages or problems caused by use of these instructions. These instructions require a moderate level of technical ability and proficiency in the use of hand tools, as well as a general understanding of electronic components. Buyer assumes full responsibility for the installation of this replacement battery.

 

 Step 1:

Using the included wrenchwrench.jpg (2203 bytes) remove the four screws from the case.

 

 Step 2:

Using the included flat head screwdriverscrewdriver.jpg (11606 bytes) pry open the IPAQ case, starting at the bottom.

 

 Step 3:

Continue prying the case towards the corners until the full length of the case pops open.

 

 Step 4:

Disconnect the connector by gently pulling on the ribbon cable.

 

 Step 5:

Using the flat head screwdriver unglue the old battery from the case cover. Apply the new battery on the case within the guide brackets. The battery should stick to the original glue spots. Please pay attention to have the original orientation (connector towards the bottom of the IPAQ).

Connect the ribbon cable by positioning it over the socket on the motherboard, pushing it in.

Snap on the cover and put back the four screws.

Your new battery will need a minimum of three hours of charging before first use.