logo.gif (2999 bytes)

See a complete list of Palm Pilot PDA batteries

See other PDA batteries: Compaq iPAQ, Sony Clie, Palm Pilot, Toshiba, Casio and more.

Palm m130 Battery Installation Guide

 button_order.gif (689 bytes)
The instructions below come with no warranty or guarantee, proper or improper assembly or use of excessive force may result in damage to the parts involved or to your PDA/Mp3 Player. By utilizing these instructions, you agree to hold Laptops For Less blameless and unaccountable for damages or problems caused by use of these instructions. These instructions require a moderate level of technical ability and proficiency in the use of hand tools, as well as a general understanding of electronic components. Buyer assumes full responsibility for the installation of this replacement battery.

 

 Step 1:

Using the included screwdriver or T5 wrench, remove the four screws from the case.

 

 

 Step 2:

Using the tip of the screwdriver, pry open the case starting with one of the top corners of the PDA. The back of the case should easily unsnap from the rest of the PDA.

 

 Step 3:

Once the case is separated, flip over the front cover to expose the battery compartment. You will notice the battery at the bottom of the PDA is attached to the motherboard by a black and red power cable.

 

 Step 4:

Using your finger, loosen the battery from its compartment. Carefully lift the battery...it should be held in place by a small amount of glue. The battery should still be attached by its power cable.

Step 5:

With the battery loose from the back of the case, flip over the motherboard section of the PDA to expose the battery connector. Gently pull on the power cable to disconnect the battery. The battery can now be removed from the PDA.

Step 6:

Please pay attention to have the original orientation (power cable towards the connector side of the PDA). Connect the power cable of the new battery by positioning it within the socket on the motherboard, pushing it in. Reapply the battery within its original glue spots.

Snap on the cover and put back the four screws.

Your new battery will need a minimum of three hours of charging before first use.
©1997- 2005 Laptops for Less Inc.
All Rights Reserved. All offers and prices are subject to change without notice.

Back