| See a complete list of Creative Labs Mp3 player batteries See other Mp3 Player batteries: iriver, Archos, Dell, ipod, RCA, Samsung and more. Zen Touch Battery Installation Guide |
|||
| The instructions below come with no warranty or guarantee, proper or improper assembly or use of excessive force may result in damage to the parts involved or to your PDA/Mp3 Player. By utilizing these instructions, you agree to hold Laptops For Less blameless and unaccountable for damages or problems caused by use of these instructions. These instruction require a moderate level of technical ability and proficiency in the use of hand tools, as well as a general understanding of electronic components. Buyer assumes full responsibility for the installation of this replacement battery. | |||
| Step 1:
Using the included Philps screwdriver remove the two screws from the top of the back case cover (near the head phone jack). |
|||
| |
Step 2:
unscrew the two remaining screws at the bottom of the back case cover. |
||
| Step 3:
Crefully wedge the included Flat Head screwdriver in the side and center of the the two housings, unclipping the case clip, using your fingers, carefully pry open the back case cover. |
|||
![]() |
Step 4:
Disconnect the power cable by gently pulling on the cable, if needed help the connector out using the Flat Head screwdriver. Please pay attention to the battery and powerr cable orientation. |
||
| Step 5:
Using your finger or the tip of the screwdriver, carefully unglue and revmove the battery from the case cover. |
|||
| Step 6:
Insert the new battery by lining the connector with the socket. push the connector in with the tip of the screw driver if needed. Be sure the battery fits within the guide brackets and does not obstruct the screw holes. Snap on the cover and put back the four screws. Your new battery will need a minimum of three hours of charging before first use. |
|||
| ©1997-
2003
Laptops for Less Inc. All Rights Reserved. All offers and prices are subject to change without notice. |
|||